Related Manuals for Joie Curve C 0925
Summary of Contents for Joie Curve C 0925
- Page 1 Curve MODEL C 0925 instruction manual IMPORTANT: KEEP THIS INSTRUCTION BOOKLET IN THE PLACE PROVIDED AT THE BACK OF THE CHILD RESTRAINT...
-
Page 2: Table Of Contents
Welcome to Joie CONTENTS Congratulations on becoming part of the Joie family. We are so excited to be part of your journey with your little one. While traveling with the Joie Curve™ Child Restraint you are using a high qual- Quick Reference - Rearfacing .................. - Page 3 Quick Reference - Restraint Installation Rearward Facing Quick Reference - Rearward Facing Use IMPORTANT: After reading this Quick Reference read the following instructions carefully IMPORTANT: After reading this Quick Reference read the following instructions carefully Head Liners and Infant Vehicle Sash Belt Insert - only use for - must always be routed smaller children who...
-
Page 4: Quick Reference - Forward Facing
Quick Reference - Restraint Installation Forward Facing Quick Reference - Forward Facing Use IMPORTANT: After reading this Quick Reference read the following instructions carefully IMPORTANT: After reading this Quick Reference read the following instructions carefully Shoulder Straps - must Tether Strap - must always be used when the always be at correct height restraint is installed in a vehicle. -
Page 5: Warnings
ADDITIONAL WARNINGS WARNINGS This Child Restraint is: GENERAL • Use the restraint exactly as shown in the instructions. To be used only in a rearward-facing position until the infant’s shoulders reach WARNINGS • Supervision of children is needed because they may be able to the lower shoulder height marker (approximately 12 months of age). - Page 6 Never install the Child Restraint in a seat VERY IMPORTANT: Only replace the cover with with a front airbag. DEATH or SERIOUS a Joie supplied replacement cover with identi- INJURY may occur. Refer to your vehicle cal shoulder height markers or a replacement Owners Manual for airbag warnings and cover meeting AS/NZS 8005.
-
Page 7: Features
Features Features Adjustable Head Support Recline Angle Adjustment Handle Sash Belt Lock-off Device Base Seat Pad Crotch Pad Head Support Adjuster Handle Rearward-Facing Vehicle Belt Slot Harness QR Buckle Shoulder Harness Strap Top Tether Storage Bag Forward-Facing Vehicle Belt Slot Harness Adjuster Cover Shoulder Harness Strap Covers Top Tether... - Page 8 Securing a Child in the Restraint - Recline Angle Securing a Child in the Restraint - Shoulder Strap height Correct Recline Angle Correct positioning of the shoulder straps is essential for your baby's safety. When used rear facing the restraint must always be fully reclined.
- Page 9 IMPORTANT: Children are safer rear facing. Joie recommends that they remain rear facing until they are 12 months of age. 2 Press button to open the quick release buckle.
- Page 10 Securing a Child in the Restraint - Securing the Harness Securing a Child in the Restraint - Adjusting the Harness 3 Place child in restraint in 5 Tighten harness by pulling on the ad- seated position, firmly against both the juster strap at the front of the restraint.
-
Page 11: Rearward Facing
Installing the Restraint - Using Vehicle Belts Installing the Restraint - Using Vehicle Belts Place the restraint on the vehicle seat The installed restraint should look like Sash Belt rearward facing. this: See page 11 for recommended positions A) Vehicle belts securely connected to the in the vehicle. -
Page 12: Recline Angle
Liner and Infant Insert Securing a Child in the Restraint - Recline Angle Correct Recline Angle Rear Facing This restraint has a soft padded liner for When used forward facing the restraint use with a baby or small child. Use this must always be correctly reclined. - Page 13 Securing a Child in the Restraint - Shoulder Strap height Securing a Child in the Restraint - Shoulder Strap height labels This restraint has shoulder height level Correct positioning of the shoulder straps labels. is essential for your child's safety. Requirement: The shoulder straps must be posi- tioned near to the child’s shoulders, but...
- Page 14 Securing a Child in the Restraint - Securing the Harness Securing a Child in the Restraint - Securing the Harness FIRST CHECK SHOULDER STRAP 3 Place child in restraint in HEIGHT AND ADJUST IF NECESSARY. seated position firmly against both the See page 23 back and bottom of the restraint.
-
Page 15: Installing The Restraint
Securing a Child in the Restraint - Adjusting the Harness Installing the Restraint - Using Vehicle Belts See page 11 for recommended positions 5 Tighten harness by pulling on the ad- in the vehicle. juster strap at the front of the restraint. Place the restraint on the vehicle seat forward facing. -
Page 16: Cover Removal & Refit
Cover Removal Installing the Restraint - Using Vehicle Belts While pressing the child restraint down To Remove firmly into the vehicle seat, pull the vehicle 1. Remove the Infant Insert and Crotch sash belt until both lap and sash belts are Pad if fitted. -
Page 17: The Next Restraint
The Next Restraint Refit Cover To Refit This restraint is suitable for a child of av- erage size up to approximately four years 1. Place the main cover into the seat and of age. thread the QR buckle through the slot in When the child has outgrown this re- the cover, and move the harness lap straint, the next suitable type of restraint... -
Page 18: Top Tether Warnings
TOP TETHER WARNINGS Top Tether Use THIS RESTRAINT MUST BE ATTACHED TO A CHILD RESTRAINT UPPER ANCHOR- This child restraint has a tether strap per- Adjust the tether tension until the webbing AGE POINT IN THE CAR. manently attached to the back of the seat. is pulled tight - but not so tight that it lifts the child restraint off the vehicle seat. -
Page 19: Tether Anchorage Installation
Top Tether Use Tether Anchorage Installation Always connect the snap hook securely to the If the car is fitted with a child restraint an- Attachment anchorage fitting. chorage point: Bolt Locate the anchorage point behind the rear Lock Washer seating position (consult the vehicle owners handbook for location of the anchorage point). -
Page 20: Tether Anchorage Installation
Maintenance Tether Anchorage Installation HARNESS BUCKLE SEAT COVER If the car is not fitted with a child restraint Attachment Wash with cold water at less than 30 To clean the buckle: rinse using warm anchorage point: Bolt degrees C. water. DO NOT use any soaps, solvents For sedans only - drill a 9 mm hole in the parcel Anchor or lubricants. - Page 21 Australia Power Brands Pty Ltd ACN 081952561 Bambino International Division 82 Bellingara Road, Miranda, NSW 2228 P.O. Box 2145, Taren Point, NSW 2229, Australia. Phone: (02) 8543 5570 Fax: (02) 8543 5571 P - IM 0212A - O ct 15.
Need help?
Do you have a question about the Curve C 0925 and is the answer not in the manual?
Questions and answers