Tandby Mode - Hitachi CP-TW2505 User Manual

OPTION menu
Item
SERVICE
(continued)
(continued on next page)
80
The following items are exempted.
IWB: CALIBRATE SETUP
SETUP: SETUP MEMORY, LAMP TIME,
OPTION: SCHEDULE_DATE AND TIME,
NETWORK: WIRELESS SETUP
SECURITY: MY TEXT DISPLAY
• Operation is not available if SECURITY_
CLONNING LOCK is turned ON.
• The Screen_MyScreen can only be loaded.
CLONING load function on STANDBY MODE
CLONING
• While the projector is in STANDBY MODE, push
(continued)
the
► button, and then press the ▲ button to start
operating the CLONING load function.
• During loading process, the three indicators of
control panel (POWER (orange), TEMP, LAMP)
will remain on.
• After the loading process, the three indicators
(POWER (orange), TEMP, LAMP) will turn off.
Then, you can remove the USB storage device.
• If the loading fails, the three indicators (POWER
(orange), TEMP, LAMP) will blink at the same
time.
• CLONING is invalid with the following conditions.
- CLONING LOCK is turned ON.
With this condition, the three indicators (POWER
(orange), TEMP, LAMP) will blink at approximately
three seconds intervals.
- If the STANDBY MODE is set to SAVING.
- If there is no USB memory inserted into USB
TYPE A port.
- If PIN LOCK is not being released.
- If a system error occurs.
Description
FILTER TIME
SERVICE(GHOST)
(SIMPLE ACCESS POINT),
WIRELESS SETUP
(INFRASTRUCTURE)
AND WIRED SETUP
(IP ADDRESS, SUBNET MASK,
DEFAULT GATEWAY), MY IMAGE,
PRESENTATION, AMX D.D.
button of control panel together with the