HIKVISION UD01171B User Manual page 119

Enter the Face Detection settings interface, Configuration > Event > Smart
1.
Event > Face Detection.
Check the Enable Face Detection checkbox to enable the function.
2.
Check the checkbox of Enable Dynamic Analysis for Face Detection, and then
3.
the detected face is marked with green rectangle on the live video.
Note: To mark the detected face on the live video, go to Configuration > Local
to enable the Rules.
Click-and-drag the slider to set the detection sensitivity. The Sensitivity ranges
4.
from 1 to 5. The higher the value is, the more easily the face can be detected.
Click Arming Schedule to set the arming schedule. Refer to Task 2 Set the
5.
Arming Schedule for Motion Detection in Section 10.1.1 for detailed steps.
Click Linkage Method to select the linkage methods for face detection. Refer to
6.
Task 3: Set the Linkage Method Taken for Motion Detection in Section 10.1.1.
Network Camera User Manual
Figure 10-19 Face Detection
118