Remote Control; Multi Protective Function - ElectrIQ SILENT10 User Manual

1.7 Sleep mode key
In cooling mode, press the
Press again to cancel.
It increases the target temperature with 1 C after an hour and readjust to 2 C
increase after 2 hours. Sleep mode is not operational under dehumidification and
fan only mode.
1.8 Swing button
again to cancel. Stopping the swing will lock the louvres position.

2. Remote control

1.Power Press this key to turn the unit on/off.
2. Timer Press this key to set time. Once set,
selected time will flash 5 times as confirmation
3. Down Press this key to turn down the temperature
or adjust time.
4. Mode Press this key to choose cooling, heating,
dehumidifying or fan mode
5. Up Press this key to turn up the temperature or
adjust time.
6. Fan Press this key to set low/medium/high fan
speed.
7. Sleep Only in cooling function
enable sleep mode.
8. Swing Press this key to control swing function.

3. Multi protective function

3.1 Anti-freezing protecting control:
When the ambient temperature is low while in Cooling Mode, the compressor and water
motor will stop working if the copper coil temperature reaches <2 C for over 20 seconds.
When the copper coil temperature increases to >8 C, the protection will be stopped
automatically.
3.2 Water-full protection:
When the water level in the internal water tank is surpassing the maximum level, the
unit will alert automatically and main led light will flash. Please discharge water in the
machine according to "Water Drainage" section
:
key and the unit will go into sleeping mode.
: press this key to start auto swing function left to right, press
Press this key to
Page 8 of 13