Emotiva BASX PT-100 User Manual page 19

BasX PT-100 Stereo Preamp / DAC / Tuner
Example
To turn up the Bass to +2 dB:
Press the Menu button to enter the menu.
Rotate the Volume knob until Trims is displayed.
Press the Right Button to enter the Trims Sub-menu.
Rotate the Volume knob until Bass is displayed.
Press the Right Button to enter the Bass Trim Sub-menu.
Rotate the Volume knob until Bass +02 is displayed.
Press the Menu Button, or the Volume knob, or press the Left Button three times, to exit the Menu.
The Setup Menu
Note: Some of the options in the Setup Menu may operate differently than you expect, so we
suggest you read the instructions for each before using it.
The Setup Sub-menu gives you access to the following controls:
Dim
Version
Reset
Autotune
Tunezone
Rotate the Volume knob to switch between menu items.
Dim - Allows you to configure the brightness of the front panel VFD display.
Press the Right Button to see the current setting; use the Volume knob to change the setting; and
use the Left Button to exit when you're done. The setting will automatically be saved.
Version - Displays the current firmware version of your PT-100.
Press the Left Button to exit when done; there are no other options.
Reset - Resets all settings and Tuner Presets on the PT-100 to their factory default settings.
After pressing the Right Button to select this option, you will be prompted to confirm your choice.
Press the Right Button again to confirm your choice and clear all settings; press the Left Button to
abort the process.
Autotune - Instructs the PT-100 to scan the FM radio band for stations, and load any stations it
finds into the FM tuner station presets.
After pressing the Right Button to start the Autotune process, it will proceed and complete
automatically.
Note: Using Autotune will ERASE your current FM Station Presets and replace them with the
stations found by the signal scan.
Page 15