3
INSTALLATION
Use the bracket for normal installation. The unit may be installed directly on the wall, without
the bracket, only if the following three conditions are met;
•
The mounting height is less than 3m (9'10").
•
Horizontal adjustment is not necessary.
•
The ground must be level.
3-1
INSTALLING WITH BRACKET
Using the bracket makes it possible to adjust the unit horizontally by ±90°.
In cases where the ground is uneven and/or not parallel with the base of the unit, it is possible
to adjust the unit vertically by ±20°.
90°
Remove the Up-Down lock screw.
1
Loosen the adjustment screw two turns.
3
Adjustment screw
Caution>>
Do not loosen the
screw too much.
It may disassemble.
20°
90°
20°
2
Shaft cover
4
In
- 10 -
Caution>>
Do not change the detection
length with bracket.
Use the flaps and plates to
adjust the detection length.
Push the shaft cover clip straightly to
remove the shaft cover.
Tilt the bracket about 45° and pass
through the wire.
Shaft cover clip
Push with suitable tool.
e.g. small screwdriver
Out