Table of Contents
Advertisement
Determine the horizontal direction (left or
5
right) of the detector before installing the
bracket on the wall.
To the right
Open the Up-Down lock screw knockout
7
for connecting the bracket.
Knockout with 4×20
tapping screw (screwkit)
Tighten the adjustment screw clockwise.
9
Adjustment
screw
Install shaft cover into place.
11
6
To the left
8
Wiring
Wiring
hole
sponge pad
10
- 11 -
Open the wiring knockout.
Tighten screws 1 and 2, adjust the
bracket angle (refer to 3-2), then tighten
screw 3.
Perform an area check. If re-adjustment
is required, loosen screw 3 and change
the bracket angle.
After the adjustment is complete, tighten
screw 3 again.
Wire to the terminal and install the main
unit and lens on the base.
Wiring knockout
14×20 screw
Out
34×35 Up-Down
lock screw
24×20 screw
Hide quick links:
Advertisement
Table of Contents
