Configuring Tcp/Ipv6 Network Settings - Canon imageprograf IPF785 User Manual

Configuring TCP/IPv6 Network Settings

The Set./Adj. Menu is displayed.
3.
Press ▲ or ▼ to select Interface Setup, and then press the OK button.
4.
Press ▲ or ▼ to select Ethernet Driver, and then press the OK button.
5.
Press ▲ or ▼ to select MAC Address, and then press the OK button.
Note
2
In Windows, open a command prompt, or in Mac OS, start Terminal.
3
Execute the following command to add entries to the ARP table for managing IP addresses and corre-
sponding MAC addresses.
arp -s [IP address] [the printer's MAC address you have verified]
Example: arp -s xxx.xxx.xxx.xxx 00-1E-8F-xx-xx-xx
Note
4
Execute the following command to send the IP address to the printer and configure it.
ping [IP address as specified in the ARP command] -l 479
Example: ping xxx.xxx.xxx.xxx -l 479
Note
The subnet mask and default gateway are set to 0.0.0.0. Use RemoteUI to change the subnet mask and default
•
gateway to match your network settings.
Note
For details on RemoteUI, see "Using RemoteUI."
Configuring TCP/IPv6 Network Settings Configuring TCP/IPv6 Network Settings
When printing in a TCP/IPv6 network, you must configure the TCP/IPv6 settings on the Control Panel.
Follow the steps below to configure the TCP/IPv6 network settings.
1
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to
select the Settings/Adj. tab (
Note
2
Press the OK button.
452
The Set./Adj. Menu is displayed.
3
Press ▲ or ▼ to select Interface Setup, and then press the OK button.
4
Press ▲ or ▼ to select TCP/IP, and then press the OK button.
5
Press ▲ or ▼ to select IPv6, and then press the OK button.
• If the Tab Selection screen is not displayed, press the Menu button.
You can investigate the MAC address by printing an interface setting report.
•
(See "Printing Interface Setting Reports.")
• In Mac OS when using Terminal, enter the arp command in the format arp -s xxx.xxx.xxx.xxx 00:1E:
8F:xx:xx:xx. For details, refer to the help file for the command line.
• In -l, the l is the letter l.
• In Mac OS when using Terminal, enter the ping command in the format ping -s 479 xxx.xxx.xxx.xxx. For
details, refer to the help file for the command line.
).
• If the Tab Selection screen is not displayed, press the Menu button.
P.429
➔
P.448
➔
iPF785
User's Guide