Basic Operations Guide; Power On And Off - Brickcom NR-2008 User Manual

www.brickcom.com.tw

6 Basic Operations Guide

6.1 Power On and Off

6.1.1 Power On
Install the NVR correctly (as above) and then connect the power. The NVR LED should light up and the NVR will
boot automatically.
The NVR will then automatically detect any connected hardware (cameras, monitors, etc.), this process should last
about 30 Seconds. When this process has been completed the NVR will enter the multi-screen real-time surveillance
mode.
If your hard drive is not properly connected, the following message will appear on your screen.
If your hard drive is properly connected NVR start-up time is within the video recording setting time, the system
will automatically start the recording function.
18