Names Of The Buttons And The Display - TANACOM 500S Operating Manual

Names of the buttons and the display

RESET BUTTON
1
This button resets the depth counter to zero.
Make sure to press this button before you start fishing. The reset depth is used to make the auto stop function
work. (display shows
The RESET BUTTON must be quickly pressed 3 times within 2 seconds. This prevents accidental resetting. For
a total reset, when line has been broken off, press and hold the button for at least 2 seconds.
Do not continuously hold down the reset button. This will prevent any counter errors.
MODE BUTTON
2
- Pressing the MODE BUTTON
MODE DISPLAY
3
- This display allows you to change setting of each function.
- The functions that are set to work are shown on the display.
Press the MODE BUTTON
- Use the Power Lever to adjust numeric values.
- Pressing the MODE BUTTON
- Depress and hold the MODE BUTTON
- Mode change cannot be done while line is being fed.
Display
Auto Line feeding is employed. Default
setting is off.
Pressing the
appear. (If the
Auto Stop will work at 5.0m from the broadside.)
If the supply voltage drops, the indicator
will blink. (Pressing the
does not change the indication.)
Depth counter
4
- It shows the depth from the surface.
Chumming timer (Power indicator, time to wind up, timer display)
5
- The chumming timer appears when motor rotation is stopped.The timer display cannot be set to OFF.
- Indicates winding speed (winding power) while the motor is running.
). The default setting of auto stop is 2 meters.
for two seconds sets the auto stop depth. (See page 18.)
to scroll through the adjustment displays for each reel function.
sets the numeric values you have adjusted.
to return to the depth display.
Function
RESET BUTTON makes this indicator
RESET BUTTON is not pressed,
MODE BUTTON
6