P3 Line Data Reset - TANACOM 500S Operating Manual

Line data reset
This method is used for data re-input which is to be made after the main line is wound on to the
spool. This method requires a main line of 100m or longer specific length.
1.
Turn on the electricity.
2.
Press the MODE BUTTON
will show 0.0.
- Keep on pressing the button even after the alarm is activated in
two seconds and a line-feeding display appears in five seconds.
This changes the display to the line setting mode. Then, press
the MODE BUTTON so that
3.
Press the MODE BUTTON
backing line 2.
This mode shows P3 blinking on the low left of the display.
4.
Paying attention to the lineʼs color coding, pull 50m of line off of
the spool.
(Allows new depth setting)
for 10 seconds, when the display
P1 starts blinking.
3 more times and set the mode to
13
2
-The following display appears
or
Please skip this indication, it
MODE
concerns standard line only in Japan.
BUTTON
MODE
BUTTON
3
RESET
MODE
depending on the entry method.
or
RESET
MODE
Data Re-entry
display