With Backing Line; P2 Inputting Line Backing - TANACOM 500S Operating Manual

Line data input
This method requires use of Daiwa braided line that is color coded to show length and has a total
length greater than 100 m.
1.
Run the backing line through the levelwind guide and tie it onto
the spool. The levelwind threader makes this process easier.
Make sure to tie the line onto the pin found on the spool to
avoid the line slipping.
2.
Wind the backing line.
If the power lever is not already at OFF position, then pull it
back to OFF position before beginning to wind.
3.
Tie the backing line securely to the main line.
4.
Press the MODE BUTTON
will show 0.0.
P1 will be blinking.
-Keep on pressing the button even after the alarm is activated in
two seconds and a line-feeding display appears in five seconds.
This changes the display to the line setting mode. Then, press
the MODE BUTTON so that

(With backing line)

for 10 seconds, when the display
P1 starts blinking.
MODE
BUTTON
11
1
Levelwind Guide
Pin
2
OFF
3
Backing line
4
-The following display appears
depending on the entry method.
or
Please skip this indication, it
concerns standard line only in Japan.
Backing line
Power lever
Main line
Tie
RESET
MODE
or