Table of Contents
Advertisement
Functional setting operation
Auto stop
Auto stop automatically brings your terminal rig to the surface, stopping consistently at your
pre-set depth preference. It eliminates the need to constantly monitor depth as it comes up.
- In the electric winding mode, the winding stops automatically at a preset auto stop depth.
- After the rig is ready, reset the depth counter to zero by pressing the
(water surface zero setting) (After this,
- Without pressing the
RESET
- If you have pressed the
winding stops at 2 m.
- When the stop depth is set by pressing the
the alarm sounds every 2 m above the depth of 6 m, and winding stops at the set depth.
- After auto stop stops winding, the power lever can be used up to
such as, power lever and PICKUP, cannot be employed until the
- Depending upon the rocking of the boat or sinker weight, auto stop depth can overrun slightly. Should this
happen, increase the depth of the auto stop.
(3. Auto stop function)
appears on the display)
BUTTON, winding stops at a depth of 5 m.
RESET
BUTTON, the alarm sounds at 2m increments above the depth of 7 m, and
MODE
RESET
BUTTON.
0.0
m. However, above
RESET BUTTON
Set the depth to 0 and throw in your rig.
17
BUTTON.
0.0
m, motor winding
is pressed.
RESET
MODE
Hide quick links:
Advertisement
Table of Contents
