Line Feeding Function - TANACOM 500S Operating Manual

Functional setting operation

Line feeding function

The line feeding function lets out line with the motor assisting the spool.
- The line feeding mechanism begins to work at a depth of 2.5 m
below the pre-set auto stop depth.
- If line feeding stops while a rig is falling, it will not start again
unless you wind up the line to the auto stop depth and start
again.
- While line feeding, the alarm is activated after four minutes and
stops the line feeding for safety.
- Speed of the line going out is adjusted with 32 speed levels
ranging between 0 and Hi. It is adjusted in the line feeding
mode.
1.
Press the MODE BUTTON
adjustment display.
Default setting is 5.
Set the speed level with the power lever.
- Turning the power lever forward increases the value, and
bringing it back decreases the value.
2.
Pressing the MODE BUTTON
display and completes the operation.
( turns off.)
If the clutch is set to ON during line feeding, excessive line is wound in.
Reduce line feeding output and setting the line feeding to the OFF position.
Attention
(4. Line feeding function)
to show the line feeding speed
returns to the "Water Depth"
1
2
19
RESET
MODE
(adjustment of
line furnishing)
OFF
RESET
MODE