When Line Length Is Known - TANACOM 500S Operating Manual

Line data input
9.
Pull the lever back to the OFF position, after winding.
1.Do not wind the end of the line onto the spool because it causes incorrect length
calculation. Move the power lever to OFF position, and wind manually when nearing the
end of the line.
Attention
10.
Press RESET BUTTON
300. (300 is the default setting)
11.
Enter the line length with the power lever. (in the figure on the
right, line length is 280 m).
12.
Press RESET BUTTON
heard. The display should return to 0.0, completing the setting
procedure.
If "Err" appears on the display, you must use the
to re-enter the data.

(When line length is known)

for 2 seconds, until the display shows
for 2 seconds and a beep will be
MODE BUTTON
9
OFF
Do not reel in the
end of the line
10
12
10
RESET
MODE
11
MAX
OFF
RESET
MODE