Line Data Input - TANACOM 500S Operating Manual

Line data input

This method is used when the line length is known before winding. In the example below,
PE 6 – 280m is wound.
1.
Run line through the levelwind guide and tie it onto the spool.
The levelwind threader makes this process easier. Make sure to
tie the line onto the pin found on the spool to avoid the line
slipping.
2.
Move the power lever to the OFF position.
3.
Connect the clip to the power source (12V DC).
4.
Attach the cord connector to the reel.
See in page 2 for the connection method.
5.
Press the MODE BUTTON
display shows 0.0.
-Keep on pressing the button even after the alarm is activated in
two seconds and a line-feeding display appears in five seconds.
6.
An initial display appears. (The PE6-300m display appears.)
-The following display appears depending on the entry method.
Please skip this indication, it
concerns standard line only in Japan.
7.
Press MODE BUTTON
mode.
P1 will be flashing.
8.
Push the power lever forward to maximum and wind the line to
its end.
As the power lever is moved forward, the
to a tension indicator. Keep line tension between level 4 and 5
while winding on line.
-Reeling in the line increases the upper counter value.
-Do not allow line to rub against the finger guard while
winding as it will scratch the guard.
and hold for 10 seconds, until the
or
once to move to the line length input
P2 display changes
(When line length is known)
1
Pin
5
7
9
Levelwind Guide
Main line
Power lever
2
RESET
MODE
6
RESET
MODE
8
Tension indicatar