Before You Begin Fishing; Surface Depth Setting; When The Main Line Is Cut Or Broken Off - TANACOM 500S Operating Manual

Functional setting operation

Surface depth setting

Before you begin fishing, make sure the counter is set to zero at the waterʼs surface.
This is extremely important to ensure accurate fishing depth readings.
1.
Connect the reel to the battery, put the line through all the
guides, and prepare your terminal rig.
2.
Hold the rod in the normal fishing position.
3.
Lower the terminal rig to the waterʼs surface and press the
RESET BUTTON. (water surface zero setting)
The display resets to 0.0
1.When new line is wound up, or when line has been pulled under heavy tension, line
stretch may cause a gap in the depth reading at the surface. Simply reset the surface
setting with the
Attention

When the main line is cut or broken off.....

- Should your line break, revise data as follows.
- Wind the line to the rod tip, and press the
seconds. If the display shows
complete and data has been revised.
- Do not continuously hold down the reset button. This will
prevent any counter errors.

(2. Before you begin fishing)

and blinks.
RESET BUTTON.
RESET BUTTON
0.0 then your re-adjustment is
2
3
for 2
16
RESET
MODE