Configuring Drives - ATTO Technology Diamond Storage Array V-Class Installation And Operation Manual

4.5.8 Maintenance Services Commands .............................48
FcScsiBusyStatus
FirmwareRestart
MaxEnclTempAlrm
MinEnclTempAlrm
Temperature
Zmodem
ZoneRetrieve

5.0 Configuring Drives ..........................................................................49

JBOD (Just a Bunch of Disks)
RAID Level 0
RAID Level 1
RAID Level 10
RAID Level 5
Interleave
Partitions
Zones
Hot Spare sleds
Enhancing performance
5.1 JBOD .....................................................................................51
To set up the JBOD configuration
5.2 RAID Level 0 .........................................................................52
Sled-based versus disk-based
To set up RAID Level 0 groups
To remove RAID Level 0 groups from the array
5.3 RAID Level 1 .........................................................................55
To set up RAID Level 1 groups
To set up RAID Level 1 with Hot Spare sleds
To remove RAID groups
5.4 RAID Level 5 .........................................................................57
Configuring a fully-populated array
To set up one RAID Level 5 group with one Hot Spare sled
To set up two RAID Level 5 groups with two Hot Spare sleds
Configuring a partially-populated array
To set up one RAID Level 5 group with one Hot Spare sled
Removing RAID groups
5.5 RAID Level 10 .......................................................................61
To set up RAID Level 10 groups
To remove RAID groups
To set up RAID Level 10 with Hot Spare sleds:
5.6 Rebuilding RAID Level Configurations ..............................63
To reset LUN status
To synchronize mirrored drives automatically
Rebuild priority
To synchronize mirrored drives manually
ATTO Technology Inc.