Appendix D Product Safety; Safety Compliances; Emc Specifications; Radio And Television Interference - ATTO Technology Diamond Storage Array V-Class Installation And Operation Manual

Safe handling of the Diamond Storage Array helps protect its components as well as the people working with
them.
• The array is heavy (92 pounds for the floor
model, 86 pounds for the rack mount system).
Two people are needed to move it safely.
• Mechanical, shock and energy hazards are
present through the system if one or more of the
modules is removed. There are no operator-
serviceable components inside the unit except
those indicated in Hardware Maintenance on
page 85 and Hot Swap Operating Instructions
on page 87of this manual.
CAUTION CAUTION
All modular components must be replaced
by qualified personnel only.
• This equipment must be connected to a
protective earth ground in accordance with the
instructions provided in this guide. Improper
grounding may result in an electrical shock.
Power Switch Positions
On Stand-by
remove the AC power cord from the back of the
unit from both power supply inputs. The switch
on the power supply is only a standby switch and
does not disconnect the AC from the system.

Radio and television interference

Note
Note: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a commercial environment. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to correct the interference at his own
expense.
xiii
ATTO Technology Inc.

Appendix D Product Safety

• When the power
supply green LED is on,
the power source is fully
operational, delivering
power to the system.
The only way to
completely disconnect
from the system is to
• This unit is designed to only have inside
communication lines connected to it (no lines
outside the building proper).
• The array must be provided with adequate air
flow. To reduce the risk of damage, the ambient
temperature of the inlet air should not exceed
o
40 C.
• Service personnel must follow proper grounding
methods when working with or around the
system because of the array's electrostatic
sensitive components. Use a static wriststrap
when handling any components from the array.

Safety compliances

• UL 1950 3rd Edition
• TUV EN 60950, 1992+A1+A2+A3+A4+A11
• CSA 22.2 No. 950-95
• LEDs and fibre GBIC are Class 1 Laser Rated

EMC specifications

• EN 55022: class A
• EN 50204 RF Immunity 900 MHz Pulse
• EN 61000-4-8 Magnetic Immunity
• EN 61000-4-2: ESD
• EN 61000-4-3: Radiated Immunity
• EN 61000-4-4: EFT
• EN 61000-4-5: Surge
• EN 61000-4-6: Conducted Immunity
• EN 61000-4-11: Voltage Dips and Interruptions