4.5.4 Serial Port Configuration Commands
The serial port configuration may be customized by using the following commands:
SerialPortBaudRate
Sets the baud rate the Diamond Storage Array uses for its
terminal interface.
Choices: 2400, 9600, 19200, 38400, 57600, 115200
Default: 115200
Set syntax: set SerialPortBaudRate [2400 | 9600 | 19200
| 38400 | 57600 | 115200]
Get syntax: get SerialPortBaudRate
SerialPortEcho
Controls whether the Diamond Storage Array echoes
characters on its RS-232 port. Local ASCII terminal (or
terminal emulator) echo settings should be set to disabled
while in serialportecho enabled
Default: disabled
Set syntax: set SerialPortEcho [enabled | disabled]
Requires a SaveConfiguration Restart command
Get syntax: get SerialPortEcho
37
ATTO Technology Inc. Diamond Storage Array Installation and Operation Manual
SerialPortHandshake
Describes which handshaking method the Diamond
Storage Array uses for its terminal interface (hardware,
Xon/Xoff or none).
Choices: hardware, Xon or none
Default: none
Set syntax: set SerialPortHandshake [hard| Xon| none]
Requires a SaveConfiguration Restart command
Get syntax: get SerialPortHandshake
SerialPortStopBits
Configures/reports the number of stop bits per character
for the Diamond Storage Array RS -232 serial port. The
number of data bits per character is fixed at 8 with no
parity.
Choices: 1 or 2
Default: 1 stop bit
Set syntax: set SerialPortStopBits [1 | 2]
Requires a SaveConfiguration Restart command
Get syntax: get SerialPortStopBits