Table of Contents
Advertisement
The SCSI Diamond Storage Array uses a VHDCI connector and SCSI cables to connect to a host. It
automatically detects the type of Host Interface Card it is using without any intervention.
To connect the SCSI Diamond Storage Array
1
Insert a SCSI VHDCI connector into the Host
Interface Card in the back of the array. If the
SCSI array is the last device on the bus, you
must attach a VHDCI terminator to one
connector of the SCSI Host Interface Card or
connect a cable between the second connector
and the next device on the SCSI bus.
Exhibit 3.2-1 SCSI cable options.
SCSI-1
5
Fast SCSI
10
Fast Wide SCSI
20
Wide Ultra SCSI
40
Wide Ultra SCSI
40
Wide Ultra 2 SCSI
80
Ultra 3 or Ultra160
160
SCSI
Exhibit 3.2-2 SCSI interface cards: left without terminators attached; right with a terminator attached.
13
ATTO Technology Inc. Diamond Storage Array Installation and Operation Manual
3.2.2 Connecting a SCSI Array
Bus speed, MB/sec.
max.
8
8
16
16
16
16
16
2
The SCSI Host Interface Card has a rotary
binary-coded hex switch which allows you to
set the SCSI ID of the HIC. Be sure the selected
ID is different from all other SCSI devices on
the bus.
Note
If slower devices are connected on the same
SCSI bus as the Ultra 160 array, the bus
communicates at the rate of the slowest
device.
Bus width,
Max. bus lengths,
bits
meters
Single-ended
6
6
6
3
1.5
-
-
Max. device
support
LVD
-
8
-
8
-
16
-
4
-
8
12
16
12
16
Advertisement
Table of Contents
