Snmpupdates; Telnetpassword; Telnettimeout; Telnetusername - ATTO Technology Diamond Storage Array V-Class Installation And Operation Manual

SNMPUpdates

Enables or disables the SNMP Management Information
Base (MIB) database.
Default: disabled
Set syntax: set SNMPTraps [enabled|disabled]
Requires a SaveConfiguration Restart command
Get syntax: get SNMPUpdates

TelnetPassword

Specifies password for telnet session. Only one
username/password combination is available per
Diamond Storage Array. RestoreConfiguration default
sets the telnet username and password to the default
values. The password is case insensitive, with 1 to 8
characters.
Default: diamond
Set syntax: set TelnetPassword [password]
Requires a SaveConfiguration Restart command

TelnetTimeout

Specifies the number of minutes of inactivity which
elapses before a telnet session automatically times out.
Choices: 1-1440 minutes
Default: disabled
Set syntax: set TelnetTimeout [1-1440 | disabled ]
Requires a SaveConfiguration Restart command
Get syntax: get TelnetTimout

TelnetUsername

Specifies username for telnet session. Only one
username/password combination is available per
Diamond Storage Array. RestoreConfiguration default
sets the telnet username and password to the default
values.Username is case insensitive, 1 to 8 characters
Default: telnet
Set syntax: set TelnetUsername [username]
Requires a SaveConfiguration Restart command
The Telnet and SNMP protocols also use CLI
commands.
40
Ethernet CLI commands