Ethernet Commands; Ethernetspeed; Ftppassword; Ipaddress - ATTO Technology Diamond Storage Array V-Class Installation And Operation Manual

Ethernet configuration commands configure the Ethernet and TCP/IP parameters for the Diamond
Storage Array with an optional Ethernet management services card.

EthernetSpeed

Specifies the speed of the Ethernet Network to which the
Diamond Storage Array is connected.
Choices:10 (10 baseT), 100 (100 baseT), auto
Default: auto
Set syntax: set EthernetSpeed [10 | 100| Auto]
Requires a SaveConfiguration Restart command
Get syntax: get EthernetSpeed

FTPPassword

Specifies a password of up to 32 characters for an FTP
session.
Default: diamond
Set syntax: set FTPPassword
Requires a SaveConfiguration Restart command

IPAddress

Specifies the IP Address of the Diamond Storage Array
on the Ethernet network. If DHCP is enabled, the
assigned address of the Diamond is displayed. Setting this
value always modifies the internal NVRAM value of the
IP address.If IPDHCP is enabled (see below), get
command reports current IP address assigned by DHCP
server
Default IP Address: 10.0.0.1
Set syntax: set IPAddress xxx.xxx.xxx.xxx
Requires a SaveConfiguration Restart command
Get syntax: get IPAddress

IPDHCP

Selecting DHCP allow the Diamond Storage Array to
request an IP address from the network. It requires that
the Diamond be attached to a network with at least one
39
ATTO Technology Inc. Diamond Storage Array Installation and Operation Manual

4.5.5 Ethernet Commands

DHCP server. The network must have at least one DHCP
server
Default: disabled
Set syntax: set IPDHCP [enabled | disabled]
Requires a SaveConfiguration Restart command
Get syntax: get IPDHCP

IPGateway

Specifies the IP Gateway for the Diamond Storage Array
on the Ethernet network. If IPDHCP is enabled (see
above), get command reports current IP gateway assigned
by DHCP server Must conform to AAA.BBB.CCC.DDD
standard network IP addressing.
Default: 0.0.0.0
Set syntax: set IPGateway AAA.BBB.CCC.DDD
Requires a SaveConfiguration Restart command
Get syntax: get IPGateway

IPSubnetMask

Specifies the IP Subnet Mask for the Diamond Storage
Array on the Ethernet network. If DHCP is enabled, the
assigned subnet mask for the unit is displayed. Setting
this value always modifies the internal NVRAM value of
the IP Subnet Mask.
Default: 255.255.0.0
Set syntax: set IPSubnetMask AAA.BBB.CCC.DDD
Requires a SaveConfiguration Restart command
Get syntax: get IPSubnetMask
SNMPTrapAddress
Sets up IP trap address and trap level.
Default: 10.0.0.1
Set syntax: set SNMPTrapAddress [Index:1-6] [Address:
XXX.XXX.XXX.XXX] Level:Critical |Warning
|All|None]....................................
Requires a SaveConfiguration Restart command
Get syntax: get SNMPTrapAddress