Table of Contents
Advertisement
Event Configuration >> Motion Detect Trigger
Select the Enable option to enable the trigger function of the camera, so
that you can send captured images within the detecting area to the FTP
server, email receiver, Network Storage server, or the connected USB
device. You have to configure corresponding settings, such as FTP server
and email server, to enable this feature.
- Schedule Profile: Select a schedule profile from the pull-down list.
- Action: Select the destination that the captured images will be
sent to: Send Email, FTP Upload, Record to Network Storage, or
Save Image to USB.
Event Configuration >> Schedule Trigger
You can separately configure the schedule for trigger function of the
camera by Email, FTP, or Network Storage. Select the Enable option on
each item, and then select a Schedule Profile from the pull-down list and
set the Interval time.
NOTE
If the setting value of the Network Storage Recording Time Per
Event option in General Setting is longer than the Interval time in
Network Storage Schedule, the recorded file will be a continuous
video clip.
For example, if you set the Network Storage Recording Time Per
Event as 10 seconds and the Interval as 5 seconds, recorded file
becomes a non-stop video clip because the camera will record a
10-second video clip every 5 seconds.
- 40 -
Advertisement
Table of Contents
