Table of Contents
Advertisement
Network >> IP Filter
The IP Filter setting allows the administrator of the camera to limit
the users within a certain range of IP addresses to access the camera.
I
Start/End IP Address
Assign a range of IP addresses that are not allowed to access the
camera by entering the Start IP address and End IP address.
When you are finished, click Add to save the range setting. You
can repeat the action to assign multiple ranges for the camera.
For example, when you enter 192.168.0.50 in Start IP Address
and 192.168.0.80 in End IP Address, the user whose IP address
located within 192.168.0.50 ~ 192.168.0.80 will not be allowed
to access the camera.
I
Deny IP List
The list displays the range setting(s) of IP addresses that are not
allowed to access the camera. To clear the setting, select a range
of IP addresses from the list and click Delete.
Network>>Wireless
I
Wireless
The camera supports WLAN while you use the wireless network.
Select the Enable option to enable this feature.
-Network ID (SSID}: Keep the default setting of this option to
connect the camera to any access point under the infrastructure
network mode. To connect the camera to a specified access
point, set a SSID for the camera to correspond with the access
point's ESS-ID. To connect the camera to an Ad-Hoc wireless
workgroup, set the same wireless channel and SSID to match
with the computer's configuration.
- 26 -
Advertisement
Table of Contents
