Downloading Error; Firmware Update Error; Power Supply Cooling Fan (Fm4) Error; Heat Exhaust Fan (Rear) (Fm6) Error - Canon imageRUNNER ADVANCE 500i Trouble Error Codes List

Code

Downloading error

Firmware update error

E753-
This symptom occurs when trying to
0001
update the firmware of an option that is
not installed

Power Supply Cooling Fan (FM4) error

E804-
When detecting a failure of the Power
0000
Supply Cooling Fan (FM4).

Heat Exhaust Fan (Rear) (FM6) error

The lock signal was detected for 5.0
E805- seconds while the Heat Exhaust Fan
0000 (Rear) (FM6) was being stopped. *The
same status was detected again after
executing an error retry.
Heat Exhaust Fan (Rear) (FM6) rotation
error
The lock signal was not detected for 5.0
E805-
seconds while the Heat Exhaust Fan
0001
(Rear) (FM6) was being driven.
*The same status was detected again
after executing an error retry.
Heat Exhaust Fan (Front) (FM5) error
E805- The lock signal was detected for 5.0
0002 seconds while the Heat Exhaust Fan
(Front) (FM5) was being stopped. *The
27
Description Remedy
1. Check the log to identify the
location of the download error.
Check if the target option is
installed.
When the target option is not
installed:
-> The symptom is recovered by
turning OFF and then ON the
power (because there is nothing to
update)
When the target option is installed:
-> Check if the target option is
properly installed and see if the
software to download is for the
correct target option, and then
execute downloading again.
1. Check the connector connection
between the Power Supply Cooling
Fan (FM4) and the AC Driver PCB
(PCB4).
2. Replace the Power Supply
Cooling Fan (FM4).
1. Check the connector connection
between the Heat Exhaust Fan
(Rear) (FM6) and the DC Controller
PCB (PCB1).
2. Replace the Heat Exhaust Fan
(Rear) (FM6).
3. Replace the DC Controller PCB
(PCB1).
1. Check the connector connection
between the Heat Exhaust Fan
(Rear) (FM6) and the DC Controller
PCB (PCB1).
2. Replace the Heat Exhaust Fan
(Rear) (FM6).
3. Replace the DC Controller PCB
(PCB1).
1. Check the connector connection
between the Heat Exhaust Fan
(Front) (FM5) and the DC
Controller PCB (PCB1).