Front Alignment Motor (M4) Error; Staple Motor (M9) Error - Canon imageRUNNER ADVANCE 500i Trouble Error Codes List

Front Alignment Motor (M4) error

At initialization of the Front Alignment Plate, the
E530-
Front Alignment Plate failed to move from the Front
0001
Alignment Plate HP Sensor (S4) although the Front
Alignment Motor (M4) was driven for 10mm.
Front Alignment Motor (M4) error
At initialization of the Front Alignment Plate, the
E530- Front Alignment Plate failed to be detected by the
0002 Front Alignment Plate HP Sensor (S4) although the
Front Alignment Motor (M4) was driven for
780msec.

Staple Motor (M9) error

E531- The Stapler failed to move from the Staple HP
8001 Sensor (S11) within the staple execution time
(450msec).
Staple Motor (M9) error
After execution of staple operation, the Staple Unit
could not be detected by the Staple HP Sensor
E531- (S11) within 460msec although the motor was
8002 operated in the positive direction. And then, the
Staple Unit could not be detected by the Staple HP
Sensor (S11) within 460msec although the motor
was rotated in the negative direction.
Code
E537- Rear Alignment Motor (M5) error
14
Description
Controller PCB (PCB1).
1. Check the connector
connection of the Front
Alignment Plate HP
Sensor (S4) or the Front
Alignment Motor (M4).
2. Replace the Front
Alignment Plate HP
Sensor (S4).
3. Replace the Front
Alignment Motor (M4).
4. Replace the Finisher
Controller PCB (PCB1).
1. Check the connector
connection of the Front
Alignment Plate HP
Sensor (S4) or the Front
Alignment Motor (M4).
2. Replace the Front
Alignment Plate HP
Sensor (S4).
3. Replace the Front
Alignment Motor (M4).
4. Replace the Finisher
Controller PCB (PCB1).
1. Check the connector
connection of the Staple
Unit.
2. Replace the Staple
Unit.
3. Replace the Finisher
Controller PCB (PCB1).
1. Check the connector
connection of the Staple
Unit.
2. Replace the Staple
Unit.
3. Replace the Finisher
Controller PCB (PCB1).
Remedy
1. Check the connector