same status was detected again after
executing an error retry.
Heat Exhaust Fan (Front) (FM5) rotation
error
The lock signal was not detected for 5.0
E805-
seconds while the Heat Exhaust Fan
0003
(Front) (FM5) was being driven. *The
same status was detected again after
executing an error retry.
Developing Cooling Fan (Front) (FM7)
error
The lock signal was detected for 5.0
E820-
seconds while the Developing Cooling
0000
Fan (Front) (FM7) was being stopped.
*The same status was detected again
after executing an error retry.
Developing Cooling Fan (Front) (FM7)
rotation error
The lock signal was not detected for 5.0
E820-
seconds while the Developing Cooling
0001
Fan (Front) (FM7) was being driven.
*The same status was detected again
after executing an error retry.
Developing Cooling Fan (Rear) (FM8)
error
The lock signal was detected for 5.0
E820-
seconds while the Developing Cooling
0002
Fan (Rear) (FM8) was being stopped.
*The same status was detected again
after executing an error retry.
Developing Cooling Fan (Rear) (FM8)
rotation error
The lock signal was not detected for 5.0
E820-
seconds while the Developing Cooling
0003
Fan (Rear) (FM8) was being driven.
*The same status was detected again
after executing an error retry.
28
2. Replace the Heat Exhaust Fan
(Front) (FM5).
3. Replace the DC Controller PCB
(PCB1).
1. Check the connector connection
between the Heat Exhaust Fan
(Front) (FM5) and the DC
Controller PCB (PCB1).
2. Replace the Heat Exhaust Fan
(Front) (FM5).
3. Replace the DC Controller PCB
(PCB1).
1. Check the connector connection
between the Developing Cooling
Fan (Front) (FM7) and the DC
Controller PCB (PCB1).
2. Replace the Developing Cooling
Fan (Front) (FM7).
3. Replace the DC Controller PCB
(PCB1).
1. Check the connector connection
between the Developing Cooling
Fan (Front) (FM7) and the DC
Controller PCB (PCB1).
2. Replace the Developing Cooling
Fan (Front) (FM7).
3. Replace the DC Controller PCB
(PCB1).
1. Check the connector connection
between the Developing Cooling
Fan (Rear) (FM8) and the DC
Controller PCB (PCB1).
2. Replace the Developing Cooling
Fan (Rear) (FM8).
3. Replace the DC Controller PCB
(PCB1).
1. Check the connector connection
between the Developing Cooling
Fan (Rear) (FM8) and the DC
Controller PCB (PCB1).
2. Replace the Developing Cooling
Fan (Rear) (FM8).
3. Replace the DC Controller PCB
(PCB1).