Canon imageRUNNER 2420 Trouble Error Codes List page 4

- Optional tray motor or finisher controller
PCB failure
E542- - Optional tray HP sensor failure - Optional
0002 tray clock sensor failure - Optional tray shift
motor load failure Cannot move (to the
pickup position) within the specified time.
- Optional tray motor or finisher controller
PCB failure
- Optional tray HP sensor failure - Optional
E542-
tray clock sensor failure - Optional tray shift
0003
motor load failure The optional tray was
moved upward, but it did not reach the HP
sensor within 3000 ms.
- Optional tray motor or finisher controller
PCB failure
- Optional tray HP sensor failure - Optional
E542-
tray clock sensor failure - Optional tray shift
0005
motor load failure The encoder clock signal
was not detected two or more times when
the optional tray was operated for 300 ms.
- Stack delivery motor or finisher controller
PCB failure
- Stack delivery HP sensor failure The
E575-
stack delivery motor was driven for 2000
0001
ms in the stack delivery direction (HP
sensor approach direction), but the stack
delivery HP sensor did not turn on.
- Stack delivery motor or finisher controller
PCB failure
- Stack delivery HP sensor failure The
E575-
stack delivery motor was driven for 2000
0002
ms in the HP sensor escape direction, but
the stack delivery HP sensor did not turn
off.
Code
Shutter drive motor or finisher controller
E584- PCB failure
- Shutter open detection sensor failure -
0001
Shutter clutch failure The shutter open
Description
4
Replace the finisher controller PCB.
- Check the connector of the optional tray
HP sensor. - Check the connector of the
optional tray clock sensor. - Check the
connector of the optional tray shift motor. -
Replace the optional tray HP sensor. -
Replace the optional tray clock sensor. -
Replace the optional tray shift motor. -
Replace the finisher controller PCB.
- Check the connector of the optional tray
HP sensor. - Check the connector of the
optional tray clock sensor. - Check the
connector of the optional tray shift motor. -
Replace the optional tray HP sensor. -
Replace the optional tray clock sensor. -
Replace the optional tray shift motor. -
Replace the finisher controller PCB.
- Check the connector of the optional tray
HP sensor. - Check the connector of the
optional tray clock sensor. - Check the
connector of the optional tray shift motor. -
Replace the optional tray HP sensor. -
Replace the optional tray clock sensor. -
Replace the optional tray shift motor. -
Replace the finisher controller PCB.
- Check the connector of the stack delivery
HP sensor. - Check the connector of the
stack delivery motor. - Check the connector
of the stack delivery HP sensor. - Replace
the stack delivery motor. - Replace the
finisher controller PCB.
- Check the connector of the stack delivery
HP sensor. - Check the connector of the
stack delivery motor. - Check the connector
of the stack delivery HP sensor. - Replace
the stack delivery motor. - Replace the
finisher controller PCB.
- Check the connector of the shutter open
sensor. - Check the connector of the
shutter clutch. - Check the connector of
the shutter motor. - Replace the shutter
Remedy