E531-0002/E540-0001/0002/0003/0005/E542-0001 - Canon imageRUNNER 2420 Trouble Error Codes List

- Staple unit failure
- Staple HP sensor failure - Finisher
controller PCB failure The staple home
position had been left once, but it was not
E531-
reached again when 400 ms have lapsed
0002
since start of staple operation. In addition,
the staple home position could not be
reached by performing reverse operation
for 400 ms.
Standard tray shift motor or finisher
controller PCB failure
- Standard tray HP sensor failure -
E540-
Standard tray clock sensor failure -
0001
Standard tray shift motor load failure The
standard tray was moved but the paper
surface was not detected.
- Standard tray shift motor or finisher
controller PCB failure
- Standard tray HP sensor failure -
E540-
Standard tray clock sensor failure -
0002
Standard tray shift motor load failure
Cannot move (to the pickup position) within
the specified time.
Standard tray shift motor or finisher
controller PCB failure
- Standard tray HP sensor failure -
E540-
Standard tray clock sensor failure -
0003
Standard tray shift motor load failure The
standard tray was operated, but it did not
reach the sensor within 300 ms
- Standard tray shift motor or finisher
controller PCB failure
- Standard tray HP sensor failure -
E540- Standard tray clock sensor failure -
0005 Standard tray shift motor load failure The
encoder clock signal was not detected two
or more times when the standard tray was
operated for 300 ms.
- Optional tray motor or finisher controller
PCB failure
- Optional tray HP sensor failure - Optional
E542-
tray clock sensor failure - Optional tray shift
0001
motor load failure The optional tray was
operated, but the paper surface was not
detected.
3
- Check the connector of the staple unit. -
Replace the staple unit. - Replace the
finisher controller PCB.
- Check the connector of the standard tray
HP sensor. - Check the connector of the
standard tray clock sensor. - Check the
connector of the standard tray shift motor. -
Replace the standard tray HP sensor. -
Replace the standard tray clock sensor. -
Replace the standard tray shift motor. -
Replace the finisher controller PCB.
- Check the connector of the standard tray
HP sensor. - Check the connector of the
standard tray clock sensor. - Check the
connector of the standard tray shift motor. -
Replace the standard tray HP sensor. -
Replace the standard tray clock sensor. -
Replace the standard tray shift motor. -
Replace the finisher controller PCB.
- Check the connector of the standard tray
HP sensor. - Check the connector of the
standard tray clock sensor. - Check the
connector of the standard tray shift motor. -
Replace the standard tray HP sensor. -
Replace the standard tray clock sensor. -
Replace the standard tray shift motor. -
Replace the finisher controller PCB.
- Check the connector of the standard tray
HP sensor. - Check the connector of the
standard tray clock sensor. - Check the
connector of the standard tray shift motor. -
Replace the standard tray HP sensor. -
Replace the standard tray clock sensor. -
Replace the standard tray shift motor. -
Replace the finisher controller PCB.
- Check the connector of the optional tray
HP sensor. - Check the connector of the
optional tray clock sensor. - Check the
connector of the optional tray shift motor. -
Replace the optional tray HP sensor. -
Replace the optional tray clock sensor. -
Replace the optional tray shift motor. -