Canon imageRUNNER 2420 Trouble Error Codes List page 13

0002 Reception status error
E400- DF communication error
Reception interrupt error
0003
Code
Wrong DF
E490-
0001 The installed DF is not of a supported type.
Finisher communication error
E500- Data communication could not be
0001 performed normally. It has been retried
three times in vain.
E503- fault in communicatio n with the finisher
0001 (Finisher-Q3/ Q4)
E503- fault in communicatio n between finisher
0002 and saddle unit
E503- fault in communicatio n betweenf inisher
0003 and punch unit
fault in the backup memory of the finisher
E505-
(common among all finishers)
0001
fault in the data stored in backup memory
fault in the backup memory of the finisher
E505-
(common among all finishers)
0002
fault in the EEPROM data of the punch unit
fault in stack delivery motor (Finisher-S1)
When the stack retaining spacer is returned
E514-
to home position, the belt escape home
0001
position sensor does not go on within 1.5
sec.
fault in trailing edge assist motor (Finisher-
Q3/ Q4)
E514-
The home position sensor does not go off
0001
even when the trailing edge assist motor
has rotated for a specific period of time.
fault in stack delivery motor (Finisher-
E514- S1)When the stack retaining spacer is
0002 shifted from home position, the belt escape
home position sensor does not go off within
Description
13
Replace the reader control PCB. Replace the
ADF control PCB.
Disconnect and then connect the connector.
Replace the reader controlled PCB. Replace
the ADF controller PCB.
Install an ADF that is compatible with the
machine.
Replace the finisher controller PCB.
Replace the DC controller PCB.
Replace the finisher controller PCB.
Replace the saddle controller PCB. Check
the cable.
Replace the finisher controller PCB.
Replace the punch drive PCB. Check the
cable.
Turn off the main power. Check the wiring
of the DC controller PCB and the finisher
controller, and check the fuse of the 24-V
power supply. Thereafter, turn the main
power back on.
Replace the punch driver PCB. Replace
the finisher controller PCB.
Replace the finisher controller PCB.
Replace the stack delivery motor. Check
the stack delivery drive mechanism.
Replace the finisher control PCB. Replace
the trailing edge assist motor.
Replace the finisher controller PCB.
Replace the stack delivery motor. Check
the stack delivery drive mechanism.
Remedy