Advertisement
The power consumption when the fan and light operation is turned off by the Remote Control is about 0.5 W.
It is recommended to switch off wall switch or breaker if Ceiling Fan is not in use for long period.
This is for zero power consumption purpose.
吊扇和燈光操作被遙控器關閉時的電源消耗是大約 0.5 瓦特。
若長時間不使用吊扇， 建議您關閉牆壁開關或斷路器。
以達到零電源消耗的目的。
C)
How To Use Remote Control /
OFF/ON Button / OFF/ON
Press OFF/ON button to activate or stop the
Ceiling Fan.
'ON' - Short "Beeping" sound
'OFF' - Long "Beeping" sound
按 OFF / ON 按鈕啟動或停止吊扇。
'ON' － 發出短促的"嗶＂聲
'OFF' － 發出長長的"嗶＂聲
OFF TIMER /
Push this button to cancel "SLEEP MODE" or to
cancel "OFF TIMER".
按此按鍵取消"睡眠模式＂或取消"關閉計時器＂。
SPEED button /
Press to increase fan speed, press to
decrease fan speed. Minimum fan speed is
1, maximum fan speed is 5.
按 以曾大吊扇速度。
按 以減小吊扇速度。
最小風扇速度為 1 ，最大風扇速度為 5 。
RESET Button /
Press RESET Button to restore the Remote
Control's default setting.
按" RESET ＂鍵以恢復遙控器的預設設定。
LIGHT MODE /
Press to activate "LED" light mode function at the brightest mode level. Press for the second time to reduce to medium
brightness and the third time to lowest brightness level. Press for the fourth time to OFF.
'ON' or Change Brightness - Short "Beeping" sound
'OFF' - Long "Beeping" sound
按以啟動最亮燈光功能。按第二次將燈光調到中亮度和第三次將燈光調到最低亮度。按第四次將至關閉。
'ON' （開）或調亮度- 發出短促的"嗶＂聲
'OFF' （關）- 長長的"嗶＂聲
LCD Display /
h
LCD full display / LCD
Figure above shows that LCD Display is in off condition when OFF/ON button on Remote Control Unit is pressed.
上圖所示，當按下遙控器的 OFF/ON 鍵時， LCD 顯示屏關閉。
ATTENTION /
Transmitter /
LCD display /
LCD
Ceiling Fan
MIN
SPEED
h
TIMER
OFF/ON
OFF TIMER
CANCEL
SPEED
SLEEP MODE
LIGHT MODE
RESET
SELECT
顯示屏全顯示
12
1 / f YURAGI Button / 1 / f YURAGI
Press to activate 1 / f YURAGI mode, "1 / f " will be
shown in LCD screen.
按下以啟動 1 / f YURAGI 模式， LCD 顯示屏上將顯
示" 1 / f ＂。
MAX
SLEEP
ON
MODE
OFF TIMER /
To stop the Ceiling Fan according to the time and
YURAGI
speed setting. Off timer does not stop the operation
of LED light.
Step 1 : Select a desired speed (speed 1~5).
Step 2 : Press "SET" button to select desired time
SET
依據時間及速度設定停止吊扇。睡眠模式不會停止
LED 燈光的運作。
步驟 1 ：選擇所需的速度 (1 ~ 5) 。
步驟 2 ：按" SET ＂鍵，選擇所需的時間範圍
SLEEP MODE /
To stop the Ceiling Fan according to the time setting.
Sleep mode does not stop the operation of LED light.
Step 1 : Select a desired speed (speed 2~5).
Step 2 : Press "SET" button to select desired time
Step 3 : Press SLEEP MODE button, "ON" will be
依據時間設定停止吊扇。 睡眠模式不會停止 LED
燈光的運作。
步驟 1 ：選擇所需的速度 (2 ~ 5) 。
步驟 2 ：按" SET ＂鍵，選擇所要的時間範圍
步驟 3 ：按" SLEEP MODE ＂鍵， LCD 顯示屏上
LCD display is OFF / LCD
frame (1~8 hours)
（ 1~8 小時）。
frame (2~8 hours)
shown on LCD screen. Sleep mode is on.
（ 2~8 小時）。
顯示" ON ＂。睡眠模式開啟。
顯示屏關閉
Advertisement
