Advertisement
Blade Support Plate should be set in proper condition.
Can cause Ceiling Fan wobble or drop.
正確地安裝扇翼支撐板。
這可以導致吊扇搖晃或掉落。
Check Point After Installation /
1. Ensure the screws (10 pcs) for securing the Blade are tightly screwed.
確定用作鎖定扇翼的螺絲（ 10 枚）已被鎖緊。
2
After 5 Blades have been fi xed, fi x the Decoration Cap. Make sure marking at Motor Assembly and Decoration Cap
2
are aligned (
) .
Turn Clockwise until a click sound is heard.
裝好 5 片扇葉後，安裝裝飾帽。確保發動機組件和裝飾帽的基準標記對齊 (
順時針方向旋轉，直至聽到 「卡嗒」 聲。
Motor Assembly and Decoration Cap align at (
Decoration Cap is Opened.
Motor Assembly and Decoration Cap align at (
Decoration Cap is locked.
發動機組件和裝飾帽標記對齊 (
裝飾帽打開。
發動機組件和裝飾帽標記對齊 (
裝飾帽鎖定。
If the Ceiling Fan is found to wobble during operation, fi x the Blades at different combination of position. Repeat this step
until the Ceiling Fan stop wobbling.
如吊扇操作時搖晃，請以不同位置組合安裝扇葉。重復該步驟，直到吊扇停止搖晃。
If Ceiling Fan still wobbles after Step 3, please refer to service or sales agent.
如執行步驟 3 後吊扇仍然搖晃，請聯絡維修或銷售代理。
Check Point After Installation /
1. Ensure Decoration Cap marking and Motor Assembly marking are aligned at position as
shown.
確保裝飾帽上的標記和發動機組件上的基準標記在所示的位置對齊。
E)
Install Remote Control Holder to Wall /
1
Fix the Remote Control Holder to wall as shown in fi gure below.
1
The Wall Plugs are not needed for wooden wall.
將遙控器固定器固定於牆上，如下圖所示。
木牆不需使用牆壁插座。
STEP 3
步驟 3
Screw / 螺絲
STEP 4
步驟 4
WARNING /
).
).
) 。
) 。
ATTENTION /
STEP 2
步驟 2
Wall Plug
牆壁插座
30 mm
30 毫米
Remote Control Holder
遙控器固定器
10
) 。
STEP 1
步驟 1
Hole Diameter
Ø 6 mm
洞孔直徑
Ø 6 毫米
BRICK WALL
磚墻
Check / 檢查
OPEN
LOCKED
Check / 檢查
Advertisement
