Before Running The System - Samsung MIM-E03A Installation Manual

Test operation
Picture
Mode
① ⑦
For checking sensor
②
③ ⑧
Cancel
④
⑤
⑥
28
Explanation
3. Emergency mode
- Emergency mode shall be possible regardless of
outdoor communication error. It is available after
change DIP#5 and DIP#6 into "ON" and re-set mode.
- Enable/ disable modes: allowed for heating and how
water mode. Heater mode will be available after each
"ON" mode and disable mode can be ended by each
"OFF" input (available for Simultaneous Operation)
- Depending on the condition of heater or tank un-
installation using heater in emergency modes will
be decided. Wired remote controller will show the
sign of "Not available" according to the signal "ON" for
emergency mode in un-installation of heater or tank.
- It is not allowed to run heating mode for out door
thermostat or indoor temperature control in terms
of safety problem. Before running emergency mode,
FSV#2091, 2092 shall be on "OFF". If not, "Not available"
will be shown.

Before running the system

Make sure to confirm if refrigerant leakage, looseness of power cords and electric wires after completing installation of kit
and heat pump systems.
Control panel
Display panel
Up/Down button
DHW hot key
Outing hot key
Power(Space mode)
Power(DHW mode)
Mode button (Space mode)
Mode button (DHW mode)
Set button
View button
Daily schedule setting button
Weekly schedule setting button
Cancel/Delete button
Silent button
Schedule Set button
Lock button
Test button
29