Siemens SINAUT MD720-3 System Manual page 43

AT+CPMS Preferred Message Storage
Test
Command: AT+CPMS=?
+CPMS: (list of supported <mem1>s),(list of supported <mem2>s),(list of supported
Response:
<mem3>s),
OK
Read command
Command: AT+CPMS?
+CPMS: <mem1>,<used1>,<total1>,<mem2>,<used2>,<total2>,<mem3>,
Response:
<used3>,<total3>
OK
Executive command
Command: AT+CPMS= <mem1>,<mem2>,<mem3>
Response: +CPMS: <used1>,<total1>,<used2>,<total2>,<used3>,<total3>
OK
Parameter: The executive command selects the SMS storage <mem<x>>, being used to read, write,
etc.
<mem1>
Memory to be used for listing, reading and deleting of messages:
"SM"
"ME"
"MT"
<mem2>
Memory to be used for writing and sending of messages:
"SM"
"ME"
"MT" Sum of message storage on SIM card and device
<mem3>
Memory to be used for storage of received messages, if the routing to the connected
application is not possible. Refer to command AT+CNMI with parameter <mt>=2
"SM"
"MT" Sum of message storage on SIM card and device
<usedx>
Number of messages currently stored in <memx>.
<totalx>
Number of messages currently which can be stored in<memx>.
Notice: Example:
AT+CPMS=?
OK
AT+CPMS?
OK
AT+CPMS="ME" +CPMS: 0,100
OK
Until firmware version 1.6 inclusive, only the message storage "MT could be selected for
SINAUT MD720-3
C79000-G8976-C211
Message storage on SIM card
Message storage on device
Sum of message storage on SIM card and device
Message storage on SIM card
Message storage on device
Message storage on SIM card
+CPMS: ("ME","SM","MT")
+CPMS: "ME",0,100
SINAUT MD720-3 in Terminal Mode
43