Setting The Date And Time; Connecting The Headset - Gigaset C530HX Manual

Setting the date and time

Set the date/time so that the correct date and time can be assigned to incoming calls, and to
enable the alarm to be used.
Date and time are set using the base. The date and time can also be set on an
IP-compatible base via a time server on the network.
If the base permits it, you can set the date and time manually using the handset.
¤
Press the display key Time
or, if the date and time have already been set:
¤
. . . use
OK
The active cursor position flashes
. . . switch between cursor positions with
Enter date:
¤
. . . using enter the day, month and year in 8-digit format,
e. g.
Enter time:
¤
. . . using enter hours and minutes in 4-digit format,
e. g.
Save settings:
¤
Press the display key Save. . . . Saved is shown in the display and
a confirmation tone sounds.
Return to idle status:
¤
Press and hold the End call key
The telephone is now ready for use.

Connecting the headset

¤
Connect the headset with 2.5 mm jack to the left side of the
handset .
1
For information on recommended headsets, refer to the relevant
product page on www.gigaset.com.
The headset volume corresponds with the setting for the receiver
volume.
to select Settings
. . . change cursor position with
for 07:15.
Availability and operation of the functions
may differ on your telephone.
OK Date/Time
for 15/08/2016.
Getting started
Calls Time
Date/Time
Date:
15/08/2016
Time:
00:00
Back
1
Save
11