Toshiba RAS-B10EKVP-E Service Manual page 90

Ilmalämpöpumppujen myynti, huolto ja asennus: Jäähdytinpalvelu RefGroup Oy.
No. Part name
&
Bearing 1) Follow to the procedure in the items
2) Remove the two fixing screws used to secure
3) Raise the left side of the heat exchanger
<Caution at assembling>
• If the bearing is out from the housing, push it into
the specified position and then incorporate it in
the main body.
• After assembling the bearing base, check that it
is fitted into the stepped part of the drain pipe.
Lue lisää nettisivuiltamme: www.ilmalämpöpumput.com
Procedures
the left edge panel of the heat exchanger, and
remove the two screws used to secure the
bearing base.
slightly, and remove the bearing base.
Bearing base
!
.
Drain pipe
– 90 –
Remarks
Screw
Bearing
base
Screw
Raise the
left side
Remove in this direction
Bearing base
Bearing
Drain pipe