Set-Up & Installation - SCIFIT REX Orbi-Linear Owner's Operation Manual

Placement of Cardiovascular Machine
To aid in the placement of equipment, two wheels are
located in the rear of the unit. Movement of machine
should be done with two people. Carefully lift the
front of unit until the wheels are engaged on floor and
position the unit in the desired location.
Position the unit in a location that has a stable and
level sub-floor. Equipment should be positioned in
a location that is not in direct sunlight, in areas of
extreme temperature and humidity or where the
equipment may be splashed with water or fluids. This
machine is intended for indoor use only.
Equipment should be positioned with a safety
perimeter of 40" or 1 meter around unit.
WARNING
Failure to place the equipment on a stable and level
sub-floor with a safety perimeter can result in injury
to yourself and others.
Level Cardiovascular Machine
If the sub-floor is unlevel, the unit is equipped with
leveling end caps. The end caps are designed with
the recess of end cap off centered. This allows you to
rotate the endcap(s) to a position that will level the
equipment. After adjustment, check and make sure
end caps are fully seated against base frame tubes.
Offset Endcap
SCIFIT • Scientific Solutions for Fitness • SCIFIT • Scientific Solutions for Fitness • SCIFIT
SET-UP & INSTALLATION
Endcap
40" / 1 Meter
Safety Space
Endcap
Proper Supervision
Close supervision is required when the exercise
machine is being used by or near individuals with
disabilities. Keep unsupervised children outside the
safety perimeter.
Cleaning
Never clean the machine with organic solvents,
alcohol or bleach based cleaners. To promote a
healthy environment, wipe any sweat off of unit with
a commercially manufactured wipe designed for the
fitness industry, or a damp cloth.
4
40" / 1 Meter
Safety Space
40" / 1 Meter
Safety Space
40" / 1 Meter
Safety Space
Endcap
Endcap