Rimage everest User Manual page 27

2. Discard the used retransfer ribbon.
3. Install the new retransfer ribbon.
a. Remove the retransfer ribbon from
the packaging.
b. With the supply roll on the left side,
slide both retransfer rolls under the
retransfer ribbon carrier.
c. Install the supply roll on the left side
of the carrier and snap into place.
d. Bring the take up roll up and around
the guide rollers and snap into place.
e. Ensure the retransfer ribbon is
aligned and straight across all the
ribbon guides.
f. Take up the ribbon slack by turning
the take up roll counterclockwise
Position of lower guide.
4. Reassemble the printer.
a. Slide the retransfer carrier into the printer.
b. Close latches 1, 2, and 3.
c. Close the side cover.
5. Power on the printer. The printer is ready.
110632_H
Supply Roll
Take Up Roll
Maintain the Everest printer
21