Lamp Maintenance - Martin Mania DC3 User Manual

2. Remove the thumb screw holding the cover in place.
3. Slide the fixture cover open.
4. Vacuum or gently blow away dust and loose particles with compressed
air.
5. Remove stuck particles with an unscented tissue or cotton swab
moistened with glass cleaner or distilled water. Do not rub the surface:
lift the particles off with a soft repeated press.
6. Remove smoke, and other, residues with cotton swabs or unscented
tissues moistened with isopropyl alcohol. A commercial glass cleaner
may be used, but residues must be removed with distilled water. Clean
with a slow circular motion from center to edge. Dry with a clean, soft
and lint-free cloth or compressed air.
7. Close the fixture cover and tighten the thumb screw, taking care not to
trap any wires.
L A M P M A I N T E N A N C E
Warning Isolate from power supply before re-lamping. The lamp must
be changed if it becomes damaged or thermally deformed.
Caution Hot lamp.
Important The Mania DC3 is supplied with a Philips 6958 24V 250W 10H
lamp (Martin P/N 97000115) with an average life of 1000 hours.
The fixture must only be used with this lamp. Using any other
lamp type may damage the fixture and will invalidate the
product warranty.
Basic service 15