Reconfiguring The Beam - Martin Mania DC3 User Manual

3. Remove the two
gobo holder
retaining screws and
carefully lift the gobo
holder up and out of
the fixture.
4. Slide the gobo or
glass filter into the steel
clip in the gobo holder.
Note that for correct
focus, the coated side of
the gobo or filter should
face the lamp.
5. Replace the gobo
holder and oil wheel
cover, before reapplying
power.
R E C O N F I G U R I N G T H E B E A M
The Mania DC3 is supplied with an adjustable lens module allowing the
beam angle to be set to either 25° or 32°. A 43° beam angle converter is
also available from your Martin dealer as an accessory.
The lens is factory-set to 25°, but this can be changed to 32° as follows.
You will need the 2mm Allen key supplied with the Mania DC3 for this
operation.
To reconfigure the lens:
1. Disconnect the fixture from power and allow it to cool for 20 minutes.
20 Mania DC3 user manual