Lens Assembly; Replacing The Mains Fuse - Martin Mania DC3 User Manual

L E N S A S S E M B L Y
When you open the Mania DC3 lens module,
you may find out the hard way that it is easy
to mix up the lenses. To reassemble the
lenses correctly, see the illustration on the
right and remember that:
• The flat surfaces must face towards the
lamp
• The concave lens (C) must be placed
closest to the lamp, and the convex lens
(A) furthest away from the lamp.
R E P L A C I N G T H E M A I N S F U S E
The Mania DC3 uses a time-delay fuse for protection against current
overload. An indication that the fuse may have blown is that when power
is applied and the lamp is switched on, no light is produced.
If the fuse blows repeatedly, there is a fault with the unit that requires
service by a Martin technician.
Never bypass the fuse or replace it with one of another size or rating.
1. Unplug the mains cable from the input socket.
2. Pry open the fuse holder (located next to the mains power connector)
with a flat-head screwdriver and remove the fuse.
3. Replace the fuse with one of the same type. The fuse rating is listed on
the serial number label and in "Mania DC3 Specifications" on page 25.
4. Replace the fuse holder.
Basic service
Fuse holder
A
C
23