Replacement Of Limit Switch Kit - Permobil Stander Service Manual

Repairs

Replacement of limit switch kit.

The limit switch kit is located on the actuator. They
are aware of the position of the actuator and send
signals to the seat's control system.
Removal
1. Remove the actuator bracket on the side on
which the limit switch kit is located, see Fig. 75:1.
2. Unscrew and remove the screw holding the
clamping ring for the limit switch kit. Open the
clamping ring and remove it from the actuator,
see Fig. 75:1.
3. Loosen the screws holding the limit switch kit,
see Fig. 75:2-3.
4. Remove the protective cover sitting over the
electrical connections. The protective cover is
mounted using three screws, see Fig. 76.
5. Follow the cable from the limit switch kit to the
connections to the actuator. Loosen the
cable's two terminals. Take note of its location
for purposes of later remounting.
6. Remove the limit switch kit from the actuator.
Fitting
Mounting is performed in the reverse order.
On the stand function actuator, the limit switch kit
must be adjusted after fitting, see page 33.
1
Fig. 75. The limit switch kit
fastening points.
Fig. 76. The electrical connections are located
behind a protective cover.
Fig. 77. Electrical connections for the actuator
and the limit switch kit.
32
2 3