Configuration; Connecting A Modem Using The Cli - Nortel NN46205-310 Quick Start Manual

.
Configuration
This chapter contains configuration instructions for Ethernet Routing
Switch 8600.
Navigation
•
•
•
•
•
•
•
•

Connecting a modem using the CLI

This section describes how to connect a modem to the modem port on
a module. You can access the CLI through a modem connection to the
Ethernet Routing Switch 8690SF, 8691SF/CPU, or 8692SF/CPU modules.
The modem port is a DTE device is operating at:
•
•
•
•
ATTENTION
Nortel recommends to use the default settings for the Modem port for most
modem installations.
Copyright © 2008 Nortel Networks
.
"Connecting a modem using the CLI" (page 53)
"Connecting a modem using the NNCLI" (page 56)
"Connecting a VT-100 terminal or PC for local access" (page 58)
"Setting system date and time using the CLI" (page 59)
"Setting system date and time using the NNCLI" (page 59)
"Changing passwords using the CLI" (page 22)
"Changing passwords using the NNCLI" (page 22)
"Configuring the system using the setup utility" (page 65)
9600 baud rate
8 data bits
no parity
one stop bit
Nortel Ethernet Routing Switch 8600
NN46205-310 02.01 Standard
30 May 2008
Quick Start
53