Table of Contents
Advertisement
28 Installation preparation
Module safety
Use the following general practices to prevent the equipment damage
when working with the Ethernet Routing Switch 8600.
•
•
•
•
•
•
•
Cable and connector safety
Use the following instructions to safeguard cables and connectors while
working with the Ethernet Routing Switch 8600.
•
•
•
Copyright © 2008 Nortel Networks
.
WARNING
Risk of eye injury by laser
Fiber optic equipment can emit laser or infrared light that can
injure your eyes. Never look into an optical fiber or connector
port. Always assume that fiber optic cables are connected to a
light source.
Always wear an antistatic wrist strap that is connected to an
Electrostatic discharge (ESD) grounding jack when handling modules.
Always set modules on appropriate antistatic material.
Handle modules using the faceplate. Do not touch pins or electrical
connections.
Do not leave slots open. Fill all the slots with modules, or use slot
covers to maintain safety compliance, proper cooling, and EMI
containment in the chassis.
Ensure your environment meets the requirements for temperature,
humidity, and cleanliness.
Replace the 8010co chassis air filter regularly (approximately every
three months) to maintain proper cooling and airflow.
For instructions to replace the 8010co chassis air filter, see Nortel
Ethernet Routing Switch 8600 Routine Maintenance, NN46205-312.
Do not overtighten thumb screws or lug nuts. Tighten screws and nuts
until snug plus a quarter turn. If you use a power tool to tighten screws,
use a low torque setting (2 to 3 inches per pound [in./lb]).
Support cables to prevent stress on connectors. If the Ethernet Routing
Switch 8600 has a high cable-density configuration, install additional
cable-management equipment.
Do not exceed the bend radius recommended for the cable type
installed.
Fiber optic cables and connectors require special care.
Nortel Ethernet Routing Switch 8600
NN46205-310 02.01 Standard
30 May 2008
Quick Start
Advertisement
Table of Contents
