Nortel NN46205-310 Quick Start Manual page 57

Procedure steps
Step
1
2
3
4
5
6
7
8
Variable definitions
Variable
8databits
baud
mode
mtu
my-ip
Copyright © 2008 Nortel Networks
.
Action
Configure port parameters based on the requirements of the
modem by using the following command:
boot config sio modem
For information about the configuration requirements of your
modem, see the documentation shipped with the modem.
ATTENTION
Nortel recommends that before you configure Serial Line IP (SLIP) or
PPP, you become familiar with these protocols.
If you assign the port mode to slip, use the following command
to configure other slip parameters:
boot config sio modem [slip-compression]
[slip-rx-compression]
If you assign the port mode to ppp, use the following commands
to configure other ppp parameters:
boot config sio modem [mtu <bytes>] [my-ip
<ipaddr>] [peer-ip <ipaddr>] [pppfile <file>]
Turn off echo mode and return code messaging on the modem.
Connect the modem to the modem port.
Save the boot configuration.
Optionally, shutdown and reinitialize the port by using the
following command:
boot config sio modem restart
Reboot the switch.
Nortel Ethernet Routing Switch 8600
Quick Start
NN46205-310 02.01 Standard
30 May 2008
Connecting a modem using the NNCLI 57
--End--
Value
Set number of data bits per byte for
software to interpret.
Set baud rate for the modem.
Set serial port mode.
Sets point-to-point link maximum
transmission unit.
Sets my IP address on point-to-point link.