Teaching Actuator Paths And Directions - Multiplex SMART SX FLEXX Operating Instructions Manual

Tamiya model trucks
5.3
SMART SX FLEXX

Teaching actuator paths and directions

Make sure that the Tamiya special function is switched on (see section 3.6
"Switching the special function for Tamiya model trucks and tanks on and off" on
page 58).
Please adhere strictly to the operating sequence given in the following description:
1 Move trimming for steering to centre position:
Move the right horizontal rocker switch to
centre position by briefly pressing the
rocker switch.
An acoustic signal indicates that centre
position has been assumed.
2 Check whether the steering direction is correct:
(a) Move the right stick to the right:
The vehicle must steer to the right.
(b) Move the right stick to the left:
The vehicle must steer to the left.
If required, reverse the direction of movement of the steering with the servo
reverse function (see section 3.5 "Servo reverse" on page 58).
Page 67