3-Speed Gearbox; Switching Between Parking Supports / Hooter Or Idle / Drive Mode - Multiplex SMART SX FLEXX Operating Instructions Manual

5.2.1
5.2.2
Page 66

Moving to the right: switches idle on/off
(see section 5.2.2 "Switching between parking supports / hooter or idle
/ drive mode" on page 66)
Right vertical rocker switch
5

Optional if a receiver with more than 5 channels is used: opens
semi-trailer coupling (kingpin)

3-speed gearbox

The 3-speed gearbox is controlled via the left vertical rocker switch:

Moving forwards: shifts to one gear higher

Moving backwards: shifts to one gear lower

Switching between parking supports / hooter or idle / drive mode


The right vertical stick is used either for the hooter or for actuating the parking
supports.

The left vertical stick is used for drive mode / idle engine noise.
The left horizontal rocker switch is used to select the following functions:

The gearbox must be in the centre position,
nd
i.e. shift to 2 gear. An acoustic signal
confirms this setting.

By briefly pressing the rocker switch to the
left, you can switch between hooter and
parking supports.

By briefly pressing the rocker switch to the
right, you can switch between drive mode
and idle.
Tamiya model trucks
SMART SX FLEXX