Nortel 2210 User Manual page 47

Table 5 WLAN Handset messages, descriptions, and actions
Message
Erasing memory
Files Too Big
Flash Config Error
Initializing ...
Internal Err. # #
Invalid ID Info
Multiple SVP Svr
yyy.yyy.yyy.yyy
Must Upgrade SW!
Net Busy
xxxxxxxxxx
No DHCP Server
No ESSID
No Func Code
No Host IP xxxxxxxxxx
No IP Address
No Net Access
No Net Found
No Net Found xxxxxxxxxxx yy The WLAN Handset cannot find a
No PBX Response
No Proposal
No Reg Domain
No SVP IP
No SVP Response
yyy.yyy.yyy.yyy
No SVP Server
Description
The WLAN Handset has determined that
a download should occur and is erasing
the current software from memory.
The WLAN Handset software download
files are incorrect or corrupted.
The WLAN Handset is configured wrong. Contact your system administrator.
The WLAN Handset is performing power
on initialization.
The WLAN Handset has detected a fault
from which it cannot recover.
The VPN server did not recognize yo.
The WLAN Handset is attempting to
communicate with two WLAN IP
Telephony Managers 2245.
The WLAN Handset software is
incompatible with the hardware.
All access points are full or busy.
The WLAN Handset is unable to contact
the DHCP server.
The WLAN Handset is configured wrong. Contact your system administrator.
The WLAN Handset software download
files are incorrect or corrupted.
The WLAN Handset is configured wrong. Contact your system administrator.
Invalid IP address.
Cannot authenticate/associate with
access point
Can be caused by a variety of issues
suitable access point.
The WLAN Handset tried to send a
message to the Call Server and failed to
get a response.
The WLAN Handset is configured wrong. Contact your system administrator.
Regulatory Domain not configure
The WLAN Handset is configured wrong. Contact your system administrator.
The WLAN Handset has lost contact with
the SVP server.
The WLAN Handset is configured wrong. Contact your system administrator.
Chapter 5 Troubleshooting
Action
None. When the progress bar fills the
display line, the erase operation is
complete.
Do not turn the WLAN Handset off
during this operation.
Contact your system administrator.
None. This is informational only.
Record the error code so it can be
reported. Turn the WLAN Handset off,
then on again. If error persists, contact
your system administrator.
Contact your system administrator.
If this persists, record the information and
contact your system administrator.
Contact your system administrator.
Try call again later.
Contact your system administrator
Contact your system administrator.
Contact your system administrator.
Contact your system administrator.
Contact your system administrator.
Record the error information and contact
your system administrator.
Contact your system administrator.
Contact your system administrator.
If the problem persists, record the error
information and contact your system
administrator.
WLAN IP Handset 2210/2211/2212 User Guide
47