Updating Bootware Through A Serial Connection - H3C WX3000 Installation Manual

Figure 5-4 Reestablish the connection
Then, press Enter in the terminal window. The terminal displays the current baud rate setting:
The current baudrate is 115200 bps
===============================<BAUDRATE SET>=============================
|Note:'*'indicates the current baudrate
| Change The HyperTerminal's Baudrate Accordingly
|---------------------------<Baudrate Available>--------------------------|
|<1> 9600(Default)*
|<2> 19200
|<3> 38400
|<4> 57600
|<5> 115200
|<0> Exit
==========================================================================
Enter your choice(0-5):
After downloading files with a changed baud rate, timely change the baud rate back to 9,600 bps in
HyperTerminal to ensure the normal display on the terminal screen when the system boots or reboots.

Updating BootWare Through a Serial Connection

Enter the BootWare main menu (refer to section BootWare Main Menu on page 5-4) and select 7 to
enter the BootWare operation submenu. For details about this submenu, refer to section BootWare
operation submenu on page 5-7.
Select 3 from the BootWare operation submenu to enter the BootWare operation serial submenu:
======================<BOOTWARE OPERATION SERIAL SUB-MENU>=====================
|<1> Update Full BootWare
|<2> Update Extend BootWare
|<3> Update Basic BootWare
|<4> Modify Serial Interface Parameter
|<0> Exit To Main Menu
===============================================================================
5-10
|
|
|
|
|
|
|
|
|
|
|
|
|